Uw bron voor de laatste nieuwtjes uit de elektronicasector!
Use integrated driver and eGaN power stages to simplify the design of high frequency, high energy density switch-mode power supplies.
The new IEC 62368-1 safety standard goes into effect December 20, 2020. Take a look at the main principles behind it and how to best manage the transition.
Secure water resources by quickly acquiring accurate turbidity measurements with the right analog front-end photo-sensing system.
The automotive industry development of a secondary 48 V electrical system requires extensive isolations for safety and insulation control.
To develop intelligent and sophisticated robot systems requires innovative analog and embedded technologies and Texas Instruments offers some helpful products.
Use a high-speed 16-bit, SAR ADC to accelerate digital x-ray system throughput while maintaining accuracy and resolution.
Developers can easily create a battery-free wireless switch using an ultra-low-power Bluetooth 5.0 module and pushbutton energy harvester.
The solid state relay (SSR) is a safe, versatile, rugged on/off switch between a low level control signal and an AC/DC load, but needs to be applied carefully.
A modular system design provides a compact solution to emerging requirements for next generation PLCs.
Developers can rapidly deploy sensor hardware and software needed to build sophisticated solutions for industrial predictive maintenance.
Use advanced LDOs to maximize IoT sensor battery life while easing complexity and lowering cost.
Funnel amplifiers allow high side current measurements in systems where the load’s power supply operates at a higher voltage than the measurement circuitry.
Using multiple tiny DC-DC regulators in a design rather than fewer larger regulators can save board space and provide improved system performance.
USB-C™ cables and connectors can cope with the power required for a device such as a laptop, negating the need to carry numerous cables for different uses.
It is vital in IoT devices to have an efficient power management system to get as much energy as possible out from the battery.
Integrating USB Type-C connectors into designs requires developers pay careful attention to proper connector options and recommended layout guidelines.
Learn techniques to sequence the startup and shutdown of multi-rail power supplies used for FPGAs, DSP processors, and similar system on chip devices.
When sensing motion in battery powered wearables, developers can get the features and accuracy they need while meeting power consumption requirements.
Advanced MCUs and PMICs provide the foundation needed to meet user expectations for next generation smart products.
Using RMS-to-DC converters to measure the power of complex waveforms.
Houd uw inbox in het oog voor nieuws en updates van Digi-Key
Een e-mailadres invoeren a.u.b.